User Manual

πŸ”₯ User Manual

Using & Maintaining Your Ninth Flame Lighter

Ninth Flame lighters are crafted with precision and built to last. To ensure your lighter stays in top condition, follow the guides below β€” tailored for each type: butane, wick, and electric.


πŸ”· Butane Lighters

(Jet lighters, Torch-style, Flip-top)

How to Refill:

β€’ Hold the lighter upside down
β€’ Use only high-quality butane (3X refined or more)
β€’ Insert the nozzle firmly into the refill valve for 2–3 seconds
β€’ Repeat once if needed
β€’ Wait 2–3 minutes before using

Adjusting the Flame:

β€’ Find the adjustment dial near the refill valve
β€’ Turn + to increase, – to decrease
β€’ Adjust slowly β€” small turns make a big difference

Troubleshooting:

β€’ Sparking but not igniting – Purge air and refill
β€’ Butane spraying out – Check nozzle fit and seal
β€’ Flame flickering or too low – Increase flame height
β€’ Lighter spitting gas – Let it warm up longer after refill

Maintenance:

β€’ Purge excess air regularly
β€’ Use a small brush to clean the nozzle area
β€’ Never overfill or expose to heat


πŸ”Ά Wick Lighters

(Classic flip-top styles like Constantine, trench)

How to Refill:

β€’ Remove the insert
β€’ Use naphtha-based fluid only (e.g., Zippo)
β€’ Drip fluid into cotton until moist (don’t overfill)
β€’ Wait 1–2 minutes before using

Replacing the Wick:

β€’ Remove old wick with tweezers
β€’ Thread a new wick through the chimney
β€’ Repack the cotton around it
β€’ Trim wick tip to ~6mm length

Replacing the Flint:

β€’ Unscrew the flint cap
β€’ Remove spring and debris
β€’ Insert new flint, then replace spring and cap

Troubleshooting:

β€’ Weak flame – Add more fluid or pull up the wick slightly
β€’ Leaks – Avoid overfilling or misthreading the cap

Maintenance:

β€’ Trim burnt wick regularly
β€’ Clean ignition wheel and chimney with a dry brush


⚑ Electric Lighters

(Plasma arc or coil ignition)

How to Use:

β€’ Charge via USB (full charge ~1–2 hours)
β€’ Slide or press power switch to activate
β€’ Touch object to arc or coil to light

Troubleshooting:

β€’ Not turning on – Recharge fully
β€’ Not charging – Try a different USB cable or clean the port

Maintenance:

β€’ Keep away from water and direct heat
β€’ Clean arc points or coil using a cotton swab
β€’ Store at room temperature


🧿 Care Tips for All Lighters:

β€’ Never leave under direct sunlight or extreme heat
β€’ Keep out of reach of children
β€’ Store upright when not in use
β€’ Do not tamper with internal components


Need help?
Contact our team at sales@ninthflame.com β€” we’re here to ensure your lighter always performs as it should.